Student Center Regis South
| Equipment | Room Features | |
| • • LCD projector • Windows laptop • Podium with microphone • Ability to connect a presenter's laptop - VGA • | • Maximum Capacity 100 |
Powering Up the Equipment
The projector is controlled with the Epson remote control. Press the Power button to turn the projector on, then allow the projector time to warm up (approximately 30 seconds). The PC laptop must be turned on with the power button at the top of the keyboard.
Projector Standby
Press the A/V MUTE button on the Epson remotel to black out the projected image. Simply press the button again to take the projector out of standby mode.
Volume
Computer volume is controlled by the laptop. On the start bar, to the right side is a volume widget. Clicking here will allow the volume level to be adjusted up, down, or muted.
Connecting a Laptop
1. Plug the VGA cable into your laptop's VGA port. If your laptop does not have a VGA port, click on Laptop/Tablet Display Adapters to find out what type of adapter is needed to connect your laptop.
2. If the laptop is not displaying, press the PC button on the wall control panel.
3. If needed, set your laptop to display on a secondary display.
Powering Down the Equipment
To turn off the projector, press the Power button on the Epson remote control twice.
The PC laptop must be powered off separately. Instructions for shutting down the computer are found below.
Powering Down the Resident Laptop
1. Open the Start Menu (click on 
in the lower-left corner).
2. Click the "Shut Down" button.
Below is the old projection guide for Regis South.