Photos

Click on any image below to zoom

HS 220 seats 40 students.

HS 220 is equipped with one whiteboard.

Lighting controls are located next to the door.

A phone is located on the lectern.

Health Science 220 - Level 3 Classroom - Seats 40

Equipment	Room Features
Ceiling-mounted LCD projector MEDIABRIDGE control panel Windows computer Document camera (click here for more info) Ability to connect a presenter's laptop (HDMI) Pull-down projection screen	Seats 40 18 Tablet arm desks (movable) Light switches by door Internet and network access Phone (on lectern) Whiteboard (front wall) Click here to see what software is installed in this classroom

Powering Up the Equipment
The ceiling-mounted LCD projector is controlled using the MEDIABRIDGE control panel on the wall to the left of the whiteboard.

Click on the image below to zoom	Click on the image below to zoom

Instructor's lectern	MEDIABRIDGE control panel

On the MEDIABRIDGE control panel, under POWER press the ON button to turn on the LCD projector. After pressing ON, wait until the projector has warmed up before selecting the desired source button on the EPSON control panel. The projector will not receive the command to switch until after it has finished warming up.

The resident computer, and document camera are powered on using the appropriate button located on each device.

Projector Standby (PIC-MUTE)
Press the Ø button under SOURCE on the MEDIABRIDGE control panel once to place the projector in standby mode. Simply press the button again to take the projector out of standby.

Volume
On the MEDIABRIDGE control panel under VOLUME, press the up arrow to increase the volume, and the down arrow to decrease volume.

NOTE: Computers have their own volume controls which may need to be adjusted separately.

Click on the image below to zoom

The MEDIABRIDGE control panel

Resident Computer @ Lectern
Press the POWER button on the resident computer to turn it on. HS 220 is equipped with a Dell PC computer. USB ports are located next to the computer's power button.

Once the computer has been powered up, press the HDMI button on the MEDIABRIDGE control panel until the projector is set to HDMI 1 mode to display the image on both the LCD projector.

Click on the image below to zoom

The computer is located on
the left shelf inside the lectern

Document Camera (ELMO)
The Doc Cam’s power and lights must be turned on manually using the controls located on the camera itself. Click here for more information regarding the document camera found in this classroom.

Once the camera's power is on, press the comp button on the EPSON remote control until the projector is set to COMPUTER 1 mode to display the image on the LCD projector.

Click on the image below to zoom

The document camera is located on
the left shelf on the side of the lectern

Connecting a Laptop
The HDMI cable needed for connecting a laptop computer is found on the instructor's podium. The HDMI connection caries both video and audio. For more information see Selecting HDMI Audio Output.

Using the HDMI cable

1. Plug the HDMI cable into your laptop's HDMI port.

2. Plug the Ethernet cable into your laptop's network jack (if needed).

3. Press the HDMI button on the EPSON control panel to toggle the projector to HDMI 2 mode.

5. Turn on your laptop's power.

6. If needed, set your laptop to display on a secondary display.

Don't have an HDMI port on your laptop? Visit Training & Support to find out what type of adapter is needed to connect your laptop.

Powering Down the Equipment
On the MEDIABRIDGE control panel, under POWER press the OFF button to turn off the LCD projector. The resident computer, and document camera unit must be powered off separately. Instructions for shutting down the computer are found below.

Powering Down the Resident Computer

1. Open the Start Menu (click on in the lower-left corner).

2. Click the "Shut Down" button.

Browser not supported