Click on any image below to zoom

HS 111 seats 20 students.

HS 111 is equipped with one whiteboard.

Lighting and volume controls, along with a phone, are located on the wall behind the lectern.

Health Science 111 - Level 3 Classroom - Seats 45

Equipment		Room Features
Extron Hard-Button Control Panel Ceiling-mounted LCD projector Windows computer Document camera (click here for more info) Ability to connect a presenter's laptop (HDMI) Pull-down projection screen		Seats 45 20 Tablet arm desks (movable) Light switches by door & behind lectern Internet and network access Phone (wall-mounted behind lectern) Whiteboard (front wall) Click here to see what software is installed in this classroom

Powering Up the Equipment
The equipment is controlled from the lectern using a white multi-button Crestron Control Panel.

Click on the image below to zoom		Click on the image below to zoom

Instructor's lectern		Extron Control Panel

Press the On button on the Extron. After pressing ON, the button will blink red for 10 seconds while the projector turns on and warms up.

The resident computer and document camera are powered on using the appropriate button located on each device.

Projector Standby (PIC-MUTE)
Press the MUTE button on the Extron once to place the projector in standby mode. Simply press the button again to take the projector out of standby.

Volume

The adjustment of volume is done using the Volume knob located in the lower-left corner of the Extron.

NOTE: Computers have their own volume controls which may need to be adjusted separately.

Resident Computer @ Lectern
Press the POWER button on the resident computer to turn it on. HS 111 is equipped with a Dell PC computer. USB ports are located next to the computer's power button.

Once the computer has been powered up, press the PC button on the Extron to display the computer on the projector and monitor.

Click on the image below to zoom

The computer is located on
the right shelf of the lectern

Document Camera (ELMO)

The Doc Cam's power and lights must be turned on manually using the controls located on the camera itself. Click here for more information regarding the document camera found in this classroom.

Once the camera's power is on, press the DOC CAM button on the Extron to display on the projector and monitor.

The document camera is located on the left of the instructor's lectern.

Connecting a Laptop
The HDMI cable needed for connecting a laptop computer is found on the instructor's podium. The HDMI connection caries both video and audio. For more information see Selecting HDMI Audio Output.

Using the HDMI cable

1. Plug the HDMI cable into your laptop's HDMI port.

2. Plug the Ethernet cable into your laptop's network jack (if needed).

3. Press the HDMI button on the Extron.

5. Turn on your laptop's power.

6. If needed, set your laptop to display on a secondary display.

Don't have an HDMI port on your laptop? Visit Training & Support to find out what type of adapter is needed to connect your laptop.

Powering Down the Equipment
Press the OFF button on the Extron to shut down the projector.

The resident computer and document camera are each powered off separately. Instructions for shutting down the computer are found below.

Powering Down the Resident Computer

1. Open the Start Menu (click on in the lower-left corner).

2. Click the "Shut Down" button.

Browser not supported