Churchill Tower 205 - Level 3 Classroom - Seats 42
| | • • - SMART Board Interactive Whiteboard (click here for more info)
|
• • • - DVD/VCR combo unit with remote control
|
• - Ability to connect a presenter's laptop
|
| • Seats • - Tablet arm desks (non-movable)
|
• Light • - Internet and network access
|
• - Phone (located in hallway)
|
•
Powering Up the Equipment
The LCD projector is controlled using the Extron Control Panel located beneath the SMART Board's pen tray. using the Epson remote control.
| Click on the image below to zoom |
| | Click on the image below to zoom |
 Image Modified
|
|  Image Modified
|
| Instructor's table |
|
Press the ON button to turn on the LCD projector. After pressing ON, wait until the button has stopped flashing before selecting the desired source button on the Extron Control Panel. The projector will not receive the command to switch until after it has finished warming up.
The resident computer and DVD/VCR combo unit are powered on using the appropriate button located on each device.
Volume
The adjustment of volume is done using the knob located on the right speaker of the SMART Board.
NOTE: Computers have their own volume controls which may need to be adjusted separately.
Resident Computer @ Equipment Rack
Press the POWER button on the resident computer to turn it on. CT 205 is equipped with a HP computer. USB ports are located next to the computer's power button.
Once the computer has been powered up, press the PC button on the Extron Control Panel to display the image on both the monitor and LCD projector simultaneously.
| Click on the image below to zoom |
 Image Modified
|
| The computer is located on top of the rack |
SMART Board Interactive Whiteboard
The SMART Board Interactive Whiteboard is connected for use with the room's resident computer. After logging in to the computer, press the PC button on the Extron Control Panel. The SMART Board software will automatically load after you log in to the computer.
Click here for more information regarding the SMART Board Interactive Whiteboard found in this classroom.
DVD or VHS Tape Playback (via the DVD/VCR combo unit)
Once the equipment is powered up, insert your disc or VHS tape into the SONY DVD/VCR combo unit. The combo unit is controlled using the buttons on the unit or the corresponding SONY remote control provided.
| Click on the image below to zoom |
 Image Modified
|
| The DVD/VCR combo unit is in the rack |
Press the DVD/VCR button on the Extron Control Panel to display the DVD/VCR image on the LCD projector. To switch between DVD and VCR modes, use the DVD and VIDEO buttons found on the combo unit itself.
Connecting a Laptop
The cables needed for connecting a laptop computer are found on the equipment rack next to the SMART Board.
| |
Plug | Plug the VGA cable into your laptop's VGA port. |
 Image Modified |
| 2. Plug the audio cable into your laptop's headphone jack. |
 Image Modified |
| 3. Press the LAPTOP button on the Extron Control Panel. |
|
| 4. Turn on your laptop's power. |
Don't have a VGA port on your laptop? Visit Training & Support to find out what type of adapter is needed to connect your laptop.
Powering Down the Equipment
Press the OFF button on the Extron Control Panel to turn off the LCD projector. The resident computer and DVD/VCR must be powered off separately. Instructions for shutting down the computer are found below.
Be sure to remove any media from the equipment before shutting it down.
Powering Down the Resident Computer
1. Open the Start Menu (click on 
in the lower-left corner).
2. Click the "Shut Down" button.
