...
...
Health Science 220 - Level 3 Classroom - Seats 40
| Equipment | Room Features |
|
|
Powering Up the Equipment
The ceiling-mounted LCD projector is controlled using the MEDIABRIDGE control panel on the wall to the left of the whiteboard.
| Click on the image below to zoom | Click on the image below to zoom |
|
|
| Instructor's lectern | MEDIABRIDGE control panel |
On the MEDIABRIDGE control panel, under POWER press the ON button to turn on the LCD projector. After pressing ON, wait until the projector has warmed up before selecting the desired source button on the EPSON control panel. The projector will not receive the command to switch until after it has finished warming up.
The resident computer, and document camera are powered on using the appropriate button located on each device.
Projector Standby (PIC-MUTE)
Press the Ø button under SOURCE on the MEDIABRIDGE control panel once to place the projector in standby mode. Simply press the button again to take the projector out of standby.
Volume
On the MEDIABRIDGE control panel under VOLUME, press the up arrow to increase the volume, and the down arrow to decrease volume.
NOTE: Computers have their own volume controls which may need to be adjusted separately.
| Click on the image below to zoom |
|
| The MEDIABRIDGE control panel |
Resident Computer @ Lectern
Press the POWER button on the resident computer to turn it on. HS 220 is equipped with a Dell PC computer. USB ports are located next to the computer's power button.
Once the computer has been powered up, press the HDMI button on the MEDIABRIDGE control panel until the projector is set to HDMI 1 mode to display the image on both the LCD projector.
| Click on the image below to zoom |
|
| The computer is located on the left shelf inside the lectern |
Document Camera (ELMO)
The Doc Cam’s power and lights must be turned on manually using the controls located on the camera itself. Click here for more information regarding the document camera found in this classroom.
Once the camera's power is on, press the comp button on the EPSON remote control until the projector is set to COMPUTER 1 mode to display the image on the LCD projector.
| Click on the image below to zoom |
|
| The document camera is located on the left shelf on the side of the lectern |
Connecting a Laptop
The HDMI cable needed for connecting a laptop computer is found on the instructor's podium. The HDMI connection caries both video and audio. For more information see Selecting HDMI Audio Output.
| Using the HDMI cable |
|
| 1. Plug the HDMI cable into your laptop's HDMI port. |
|
| 2. Plug the Ethernet cable into your laptop's network jack (if needed). |
| 3. Press the HDMI button on the EPSON control panel to toggle the projector to HDMI 2 mode. |
| 5. Turn on your laptop's power. |
| 6. If needed, set your laptop to display on a secondary display. |
Don't have an HDMI port on your laptop? Visit Training & Support to find out what type of adapter is needed to connect your laptop.
Powering Down the Equipment
On the MEDIABRIDGE control panel, under POWER press the OFF button to turn off the LCD projector. The resident computer, and document camera unit must be powered off separately. Instructions for shutting down the computer are found below.
Powering Down the Resident Computer
1. Open the Start Menu (click on 
2. Click the "Shut Down" button.