Page Comparison

Health Science 206 - Level 3 Classroom - Seats 40

Powering Up the Equipment
The ceiling-mounted LCD projector is controlled using the wall-mounted Extron Control Panel located on the wall behind the lectern.  

Press the ON button to turn on the LCD projector. After pressing ON, wait until the button has stopped flashing before selecting the desired source button on the Extron. The projector will not receive the command to switch until after it has finished warming up.

The resident computer, document camera, and DVD player are all powered on using the appropriate button located on each device.

Projector Standby (AV MUTE)
The AV MUTE button is located to the right of the display ON/OFF buttons. Pressing this button once will place the projector in standby (or pic-mute) mode, as well as mute room audio. While this mode is active, the button will flash. Simply press the button again to take the projector out of standby mode and unmute the audio.

Volume
The adjustment of volume is done using the knob located on the Extron Control Panel. Rotate the knob clockwise to increase the audio volume or counterclockwise to decrease it. The LED lights to the left of the volume knob indicate the current audio level. The top light will flash red when the volume level is at 100%.

NOTE: Computers have their own volume controls which may need to be adjusted separately.

Resident Computer @ Lectern
Press the POWER button on the resident computer to turn it on. HS 206 is equipped with a Dell computer. USB ports are located next to the computer's power button.

Once the computer has been powered up, press the PC button on the Extron to display the image on both the monitor and LCD projector simultaneously.

Document Camera (ELMO)
The Doc Cam's power and lights must be turned on manually using the controls located on the camera itself. Click here for more information regarding the document camera found in this classroom.

Once the camera's power is on, press the DOC CAM button on the Extron to display the image on both the monitor and LCD projector simultaneously.

DVD Playback (via the DVD player)
Once the equipment is powered up, insert your disc into the SONY DVD player. The unit is controlled using the buttons on the corresponding SONY universal remote control provided.

Press the DVD button on the Extron to display the DVD image on both the monitor and the LCD projector. 

NOTE: When using the SONY remote control, point the remote control at the SONY DVD player.

Connecting a Laptop
The HDMI cable needed for connecting a laptop computer is found on the instructor's lectern.  The connection caries both video and audio.  For more information see Selecting HDMI Audio Output. 

Using the HDMI cable

Image Added

1. Plug the HDMI cable into your laptop's HDMI port.

Image Added

2. Plug the Ethernet cable into your laptop's network jack (if needed).

3. Press the LAPTOP button on the Extron.

4. Turn on your laptop's power.

5. If needed, set your laptop to display on a secondary display.

Don't have an HDMI port on your laptop? Visit Training & Support to find out what type of adapter is needed to connect your laptop.

Powering Down the Equipment
Press the OFF button on the Extron to turn off the LCD projector.

The resident computer, document camera, and DVD player must be powered off separately. Instructions for shutting down the computer are found below.

Be sure to remove any media from the equipment before shutting it down.

Image Added Powering Down the Resident PC

1. Open the Start Menu (click on Image Added in the lower-left corner).

2. Click the "Shut Down" button.