Versions Compared

Old Version 6

changes.mady.by.user Nathan Johnson

Saved on

compared with

New Version 7

changes.mady.by.user Nathan Johnson

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Clarified power info.

...

Powering Up the Equipment
The projector is controlled with either the Epson remote control or with the controls on the projector itself. Press the power button to turn the projector on, then allow the projector time to warm up (approximately 30 seconds).  The PC desktop must be turned on with the power button at the top of the keyboardon the front of the unit.  The document camera must be powered on with the power switch on the rear right side of the document bed.  All video input inputs to the projector goes through the HDMI switch, located next to the PC on the cart, 1 for the laptop, 2 for the PC desktop, and 3 for the document camera.

Projector Standby
Press the A/V MUTE button on the Epson remote control to black out the projected image.  Simply press the button again to take the projector out of standby mode.

Volume
Computer volume is controlled by the laptop.  On the start bar, to the right side is a volume widget.  Clicking here will allow the volume level to be adjusted up, down, or muted.

Desktop PC

A desktop PC running Windows 10 is installed in Grupp.  To display the desktop:

  1. Power on the desktop PC.
  2. Select the 1 2 button on the HDMI switch, located next to the PC on the cart.
  3. If the desktop is not displaying, press the VIDEO button on the EPSON remote control until the projector is set to HDMI mode

...

  1. Plug the HDMI cable into your laptop's HDMI port.  
  2. Select the 2 1 button on the HDMI switch, located next to the PC on the cart.
  3. If the laptop is not displaying, press the VIDEO button on the EPSON remote control until the projector is set to HDMI mode.  
  4. If needed, set your laptop to display on a secondary display.

Don't have an HDMI port on your laptop? Visit Training & Support to find out what type of adapter is needed to connect your laptop.

Document Camera

  1. The Doc Cam’s power and lights must be turned on manually using the controls located on the camera itself. Click here for more information regarding the document camera found in this classroom.

...

  1. Select the 3 button on the HDMI switch

...

  1. , located next to the PC on the cart. 
  2. If the laptop is not displaying, press the VIDEO button on the EPSON remote control until the projector is set to HDMI mode.

Powering Down the Equipment
To turn off the projector, press the Power button on the Epson remote control twice. 

...