Page Comparison

Image Added

Powering Up the Equipment
The Projector is controlled from the Epson remote control.  Press the ON button to turn the projector on. Allow the projector time to warm up (approximately 30 seconds. The PC and DVD player are located in the equipment Rack underneath the dry erase board at the front of the room, and must be powered up separately.  .  The HDMI switcher can select the PC, DVD player, or HDMI cable automatically, or by selecting the source button for each input.

The wireless keyboard for the PC can be turned on by moving the power switch on the back of the unit to the on (Green) position.

Projector Standby
The projected image can be blacked out using the AV MUTE button on the Sharp remoteEpson remote. Pressing this button will place the projector in standby mode.  Simply press the button again to take the projector out of standby mode.

Volume
The Epson remote also controls volume.  The audio level is adjusted by using the VOL+ and VOL- Volume buttons.  

Image Added

Resident Computer

1. Press the Power button on the PC in the equipment rack at the front of the room.
2. Turn on the keyboard by flipping the power switch on the back edge to ON (green).
3. Press the HDMI/Video button on the Epson remote to select the HDMI 1 connection on the projector.  
4. Press the 1 button on the switcher in the equipment rack, located above the DVD player.  
5. USB ports are located on the front of the Dell desktop near the power button.  

...

headphone jack Press the COMPUTER button on the Extron to view the Laptop on the projection screen.. Turn on your laptop's power6.

Using the VGA cable	Using the HDMI cable
1. Plug the VGA cable into your laptop's VGA port.	1. Plug the HDMI cable into your laptop's HDMI port.
2.   Plug the Ethernet audio cable into your laptop's network jack (if needed)headphone jack.	2. Press the HDMI/Video button on the Epson remoteremote to select the HDMI 1 input for the projector.
Image Added Image Removed
3. Plug the audio cable into Press the Computer button on the Epson remote to select the Computer input for the projector.	3. Turn on your laptop's	power.3
4. Turn on your laptop's power.	Image Removed	4.	4 If the image does not appear, press the 2 button on the switcher.
5. If needed, set your laptop to display on a secondary display.	5	.	If needed, set your laptop to display on a secondary display.

DVD Playback

Press the OPEN/CLOSE button on the DVD player and insert your disc into the disc tray. Press If you do not see your video, press the HDMI/Video button on the Epson remote to display the video from your DVDput the projector in HDMI 1, and press the 3 button on the switcher located above the DVD player.  Use the playback controls on either the front of the unit or the Sony remote control to play the DVD.

Image Added

Powering Down the Equipment
Press the Standby Power button twice on the Sharp the Epson remote to shutdown the projector.  

The resident computer and DVD /VHS combo unit must player must be powered off separately. Instructions for shutting down the computer are found below.
Be sure to remove any media from the equipment before shutting it down.

 Powering Down the Resident Computer

1. Open the Start Menu (click on  in the lower-left corner).

2. Click the "Shut Down" button.

...