...
Powering Up the Equipment
The projector is controlled with the Epson remote control. Press the power button to turn the projector on, then Allow the projector time to warm up (approximately 30 seconds). The PC laptop must be turned on with the power button at the top of the keyboard.
Projector Standby
Each source page (COMPUTER, LAPTOP, DOCUMENT CAMERA, DVD, etc.) has a Projector Standby button located in the lower left corner of the screen. Pressing this button will place the projector in standby mode. While this mode is active, the button will flash. Simply Press the A/V MUTE button on the Epson remote control to black out the projected image. Simply press the button again to take the projector out of standby mode.
Volume
Computer volume is controlled by the laptop. On the start bar, to the right side is a volume widget. Clicking here will allow the volume level to be adjusted up, down, or muted.
Connecting a Laptop
1. Plug the HDMI cable into your laptop's HDMI port.
2. Press the VIDEO button on the EPSON remote control until the projector is set to HDMI mode.
3. If needed, set your laptop to display on a secondary display.
Don't have an HDMI port on your laptop? Visit Training & Support to find out what type of adapter is needed to connect your laptop.
Powering Down the Equipment
To turn off the projector, press the Power button on the Epson remote control twice.
The PC laptop must be powered off separately. Instructions for shutting down the computer are found below.
Powering Down the Resident Computer
1. Open the Start Menu (click on in the lower-left corner).
2. Click the "Shut Down" button.