Page Comparison

1. When the Canisius Logo Screen appears, tap the screen to start.

2. The ceiling-mounted LCD projector will begin to warm up and the motorized screen will lower.

3. Once the projector has finished warming up, the Crestron will display the Main Menu.

Please Note: If not left powered on from the previous class, the resident computer, document camera, and lectern monitor must each be powered on separately. Instructions for doing so will be found in the appropriate section below.

The motorized projection screen automatically lowers and raises at system start and shutdown. In addition, it can be manually controlled by using the wall plate (located behind the lectern) or by using the Crestron Touch Panel.

To access the screen controls from the Crestron, press the Screen Control button to display the appropriate control screen. After adjusting the screen, press the X in the upper right corner to exit this screen.

Projector Standby is used to temporarily hide the image on the projection screen.

Press the Projector Standby button, located in the lower right of the touch panel screen, to activate it; the button will flash red while this mode is active. Simply press the button again to take the projector out of standby and display the image on the projection screen.

Volume is controlled using the Crestron Touch Panel. Volume up, down, and mute buttons are located on the right-side of the touch panel screen. These controls are accessible regardless of which source is selected for display.

1. Power on the document camera by using the slider located on the right-side of the unit near the back.

2. Press the DOCUMENT CAMERA button on the Crestron Touch Panel.

3. The image from the document camera will now display on the ceiling-mounted LCD projector and lectern monitor.

The cables needed for connecting a laptop are found on the instructor's lectern. A power outlet is located on the right-side of the lectern, if needed.

1. Plug the VGA cable into your laptop's VGA port.

2. Plug the 1/8" audio cable into your laptop's headphone jack.

3. Press the LAPTOP button on the Crestron Touch Panel.

4. Press the VGA button on the Crestron's Laptop page to display the image from the laptop on the ceiling-mounted LCD projector and lectern monitor.

Don't have a HDMI or VGA port on your laptop?
Click here to view what type of adapter you need and where to get it on campus.
Network Access
Both wired (using the provided Ethernet cable) and wireless connectivity are available in this classroom. Instructions for connecting to the wireless network can be found on Confluence here.

Composite video cables are provided to support legacy devices (examples: VHS VCR, older video camera, etc.). A power outlet is located on the right-side of the lectern, if needed.

1. Connect the composite video and audio cables to your device.

2. Press the AUX VIDEO button on the Crestron Touch Panel.

3. The image from the external device will now display on the ceiling-mounted LCD projector and lectern monitor.

1. Press the SHUT DOWN button on the Crestron Touch Panel to power off the equipment.

2. Press "Yes" to proceed with the shutdown or "No" to cancel and resume use of the room.

3. The ceiling-mounted projector will begin to cool down, the Blu-ray player will power off, and the motorized screen will raise. Once the projector has finished cooling down, the Crestron will display the Canisius Logo screen and the room can be turned back on.

Please Note: The resident computer, document camera, and lectern monitor must each be powered off separately.

The document camera is turned off by using the same slider used to turn it on. Instructions for shutting down the computer are found below.

Be sure to remove any media from the equipment before shutting it down.